Electronic Xenon PSU7000W HBX 7000 Electronic Control Gear - ROTEC GMBH

Description

Electronic Modular Power Supply for Xe Lamps

Parallel Operation of 2 x HBX3000-50

Suiting Ignitor:

ZG 180Xe with asymmetric ignition (Ri=650 μΩ)
Anode or Cathode Ground operating
Designed for Xenon short arc lamps rated up to 7000W/ 42V, 160A
Output power selectable by control Voltage 0-5V and/or presetting by Hex switch and adjustment Pot
Capable to drive lamp voltage range up to 50V (switch off @ 52V)
Designed according to IEC 61010 and IEC 60601 / HALT tested
Input voltage 240V AC, 220-262V, PF corrected
μP controlled, digital power management with high output stability over lamp Lifetime
Output short circuit protected and “Arc to Ground” protected
Operation with Cathode or Anode to Ground/PE possible
Galvanic separation of lamp output to line input, thermal shut off at 90°C
Shut off function for end of life and lamp fail parameter
PSUs cascadable for use for higher wattage Xenon lamps
Auxiliary regulated 24V/ 0.15A output for Subsystems, permanent available
line input, built-in EMI-filter: meets CE and FCC

All values are valid at 25 ± 5°C, unless otherwise noted.

INPUT DATA
Nominal Operation	Symbol	Unit	Nominal	Tolerances	Remarks
Input voltage AC-Line	U	V AC	230V/typ.	90-264	-
System wattage	P_LI	W	-	Up to 7400	Depends on P select
Input current	I_LI	A	30	< 90	Depends on P select
Line frequency	f _in	Hz	50/60	47-63	-
Line power factor	PFC	1	1.0	0.93 to 1.0	-
Line inrush current limiting	I_{LI, Peak}	A	100	Limiting Element will be shorted by Relais
Leakage Current to PE	I_{Leak_SA}	µA	<1000@230 V	-	Standalone

OTHER OPERATION DATA
	Symbol	Unit	Nominal	Tolerances	Remarks
System wattage during ignition	P_Lign	W	200	<4000	-
System wattage standby-operation	P_LIStby	W	10	<12	-

Run-up Operation
	Symbol	Unit	Nominal	Tolerances	Remarks
Run-up Current = nominal	I_max	A	200		Inside specified lamp- parameter (select by preset switch)

NOMINAL OPERATION
	Symbol	Unit	Nominal	Tolerances	Remarks
Lamp voltage	U_La	V	25-50		After run-up complete
Lamp wattage	P_La	W	up to 7000		Factory set-up 6700W
Lamp current	I_La	A	up to 160		Depend on set-up
End-Of Life-Cut off voltage	U_{La, max}	V	52	+/- 1V	After run-up completed
End-Of-Life-Cut off time	t_EOL-Off	S	<0.2
RF-Ripple of output power	∆PLarip/PLa	%	<1
50Hz-60Hz Ripple		%	<1	<4 p-p
Shift in output power with shift in input voltage	∆PLa,rip /∆U LI	1		<0.005	with nominal values
Open circuit voltage for ignition	U_OCV	V	110	105-160