Electronic Xenon PSU3000W HBX 3000 Electronic Control Gear - ROTEC GMBH

Description

Modular Electronic Control Gear for DC short arc lamps up to 3000W

Features

ZG 120Xe with asymmetric ignition (Ri=1000μ) or ZG 180 Xe for parallel mode of PSU
Anode or Cathode Ground operating
Designed for Xenon short arc lamps rated up to 3300W/ 160A
Output power selectable by control Voltage 0-5V and/or presetting by Hex switch and adjustment Pot
Output power selectable by control Voltage 0-5V, by Hex switch,adjustment potentiometer or PWM
Capable to drive lamp voltage range up to 40V (switch off @ 41V)
Input voltage range from 110V AC to 240V AC, 180V-262V for DNVGL, PF corrected
μP controlled, digital power management with high output stability over lamp Lifetime
Output short circuit protected and “Arc to Ground” protected
Operation with Cathode or Anode to Ground/PE possible
Galvanic separation of lamp output to line input, thermal shut off at 90°C
Shut off function for end of life and lamp fail parameter
PSUs cascadable for use for higher wattage Xenon lamps
Auxiliary regulated 24V/ 0.15A output for Subsystems, permanent available
line input, built-in EMI-filter: meets CE and FCC

All values are valid at 25 ± 5°C, unless otherwise noted.

INPUT DATA
Nominal Operation	Symbol	Unit	Nominal	Tolerances	Remarks
Input voltage AC-Line	U	V AC	110-240	90-264	-
Input voltage DC-Line	U	V DC	150-320	DC-input is possible but not certified
System wattage	P_Line	W	-	1800-3300	Depends on P select
Input current	I_LI	A	-	40	Depends on P select
Line frequency	f _in	Hz	50/60	47-63	-
Line power factor	PFC	1	1.0	0.93 to 1.0	-
Line inrush current limiting	Apeak	-	50	Limiting Element will be shorted by Relais
Leakage Current to PE	I_{Leak_SA}	µA	<1000@230 V	-	Standalone

OTHER OPERATION DATA
	Symbol	Unit	Nominal	Tolerances	Remarks
System wattage during ignition	P_Line	W	100	<150	-
System wattage standby-operation	P_LIStby	W	5	<6	-

Run-up Operation
	Symbol	Unit	Nominal	Tolerances	Remarks
Run-up Current = nominal	I_max	A	102		Inside specified lamp- parameter (select by preset switch)

NOMINAL OPERATION
	Symbol	Unit	Nominal	Tolerances	Remarks
Lamp voltage	U_La	V	22-40		PSU output NOT Ignitor input
Lamp wattage	P_La	W	1800 to 3300		Factory set-up 2000W
Lamp current	I_La	A	up to 160		Depend on set-up
End-Of Life-Cut off voltage	U_{La, max}	V	41	+/- 1V	After run-up completed
End-Of-Life-Cut off time	t_EOL-Off	S	<0.2
RF-Ripple of output power	∆PLarip/PLa	%	<1
50Hz-60Hz Ripple		%	<1	<4 p-p
Shift in output power with shift in input voltage	∆PLa,rip /∆U LI	1		<0.005	with nominal values
Open circuit voltage for ignition	U_OCV	V	110	105-160