Es befinden sich keine Produkte im Warenkorb.
ZG 60 Hg
HR self stopping ignitor for MH and Hg lamps
HR self stopping ignitor for MH and Hg lamps
Features
- For AC, DC-Hg and Xenon discharge lamps
- Suitable for lamps with operating voltages up to 250 V AC or DC
- Nominal Current of up to 60 A
- Threshold Voltage of about 185 V
- Symmetrical ignition Voltage 60 KVpp
- Compliant to RoHS-directive 2011/65/EC
- Self dynamical timing operation
- Extremely low noise operation @ rectangle waveforms
- Suitable for lamps with operating voltages up to 250 V AC
- Nominal current of up to 60 A with natural convection
- Self dynamical timing operation
- Extremely low noise operation @ rectangular waveforms
- Single Phase operation of 230 Vrms – 40 Hz – 440/Hz
- DC and rectangular input voltage of up to 400 Vrms
- Terminals for M6 screws and cable shoes
Technical Data
| TECHNICAL DATA | |
|---|---|
| Rated current | 60A, no additional cooling |
| Temporary over current < 90 s within a period of 5 minutes | 100 A |
| Ignition voltage | min. 56 kVpp, max. 65 kVpp, rated 60 kVpp |
| Input voltage range | DC/Rectangular.: 0-400 Vrms Threshold for ignition > 180 VAC Sine; or 240V DC or rectangle |
| Operation mode | Symmetrical : Ignition Voltage at both electrodes |
| Ignition mode control | Self dynamical timing ignitor 200 ms to 1 sec. self sourcing by ballast, no external source necessary |
| Pulse rate | Approximately 200/sec. @ 250 Vdvc |
| Repetition rate | Depends on ballast, break of 2 sec. is required for 200 V lamps, immediate restart for 100 V lamps. No automatic repetition, new sequence by voltage shut off |
| Case temperature | At the middle of potting surface : 100°C max. |
| Cable length | HV to lamp 50 cm max. for hot re-ignition: as short as possible |
| Dimensions (L x W x H) | 30 x 108 x 116 mm |
| Weight | Roughly 650 g |
| Connectors | 4 x M5 Screw-Terminals for cable-shoes |
