Es befinden sich keine Produkte im Warenkorb.
Self Stopping HR Igniter
Features
- Igniter for metal halide discharge lamps operated by electronic ballasts
- Suitable for discharge lamps with lamp voltage less than 300 V DC or square wave AC or 240 V AC and lamp currents not exceeding 20 A
- Maximum current of 14 A, temporary over current of 20 A < 90 s without cooling
- Maximum current of 16 to 20 A, temporary over current of 20 A < 90 s with cooling depending on ambient temperature
- UL approved, RoHS conform
Regulatory Specifications
Safety · IEC (UL) 60950-1
RoHS · According to 2002/95/EC
Technical Data
| TECHNICAL DATA | |
|---|---|
| Maximum current | 14 A without cooling 16 A to 20 A with forced air cooling depending on ambient temperature |
| Temporary over current < 90 s within a period of 5 min. | 20 A |
| Ignition voltage | ± 28 kV max. |
| Input voltage range | Square Wave AC or DC 0 - 300 V / sine wave 0 - 240 V AC / threshold for ignition > 150 V |
| Operation mode | Symmetrical |
| Ignition mode control | Self stopping igniter ca. 2 sec. |
| Pulse rate | About 100/sec. |
| Repetition rate | Depend on ballast |
| Case temperature | 73°C max when operating with forced air flow at test point with currents >13 A and < 16 A at an ambient air temperature not exceeding 65°C and 45°C max. when operating with forced air cooling at test point with currents > 16 A and < 20 A at an ambient air temperature not exceeding 35°C, 85°C max. when operating without forced airflow and current not exceeding 13 A |
| Cable length | HV to lamp 30 cm max. for hot re-ignition (50 cm cold) LV from ballast, limitation according to ballast spec. |
| Dimensions (L x W x H) | 83 x 68 x 22 mm |
| Weight | 257 g |
| Connectors | 4 x M3-screw terminal |
Input and output terminals are electrically connected (plus from ballast to plus to lamp and minus from ballast to minus to lamp). The ignition pulses are superimposed on input voltage.
Downloads
Ähnliche Produkte
AC Igniters
AC Igniters
AC Igniters
AC Igniters