HR self stopping ignitor ZG 8 Hg

HR self stopping ignitor for HID and Hg lamps For electronic and magnetic ballasts

Revolutionary system needs no external power source, self synchronisation with ballast
Suitable for lamps with operating voltages up to 250V AC
Nominal current of up to 9A with natural convection
Self dynamical timing operation
Extremely low noise operation @ rectangular waveforms
Compliant to RoHS-directive 2011/65/EG
Single Phase operation of 230Vrms – 40Hz/440/Hz
DC and rectangular input voltage of up to 400Vrms
Terminals for M3 screws and cable shoes

Technical Data

TECHNICAL DATA
Maximum current	9A (For US-applications, refer to figure 2 for temperature limitations regarding ambient temperature)
Temporary over current < 90 s within a period of 5 minutes	11 A
Ingnition voltage	+/- 14 kV
Input voltage range	AC-DC 0-300 V / threshold for ignition > 150V
Operation mode	Symetrical
Ignition mode control	Self stopping ignitor ca. 2 sec.
Pulse rate	Approximately 100/sec.
Repetition rate	Depend on ballast
Case temperature	90°C max
Ambient temperature	75°C or for US-applications Tmax = 90°C - 0.68°C/A2*I2 whatever is higher
Cable length	HV to lamp 30 cm max. for hot re-ignition (50 cm cold) LV from ballast, limitation according to ballast spec.
imensions (L x W x H)	59,4 x 58 x 25mm
Weight	About 130g
Connectors	High Voltage and Low Voltage cables